Follow the steps below to reset your lockbox combination, attach it securely, and ensure it’s properly locked.
Resetting Your Lockbox Combination
The lockbox is preset with a factory combination of "0-0-0-0". To set your own combination:
-
Open the Lockbox Door
Use the default combination to open the lockbox door.
-
Access the Reset Lever
Remove the rubber plug on the inside of the lockbox door to reveal the silver reset lever.
-
Set a New Combination
- Slide the reset lever in the direction indicated by the arrow.
Important: This lever can only be moved if the dials are set to the current combination.
- Hold the lever in place while rotating the dials to your new desired combination. New code should be the number 1 plus first 3 digits of address.
Tip: Keep your fingers on the reset lever to prevent it from slipping out of position.
-
Test the Lockbox
Make sure the new combination opens and closes the door reliably.
- If the lockbox doesn’t open and close properly, return to Step 1 and try again.
-
Secure the Reset Lever
Return the reset lever to its original position and replace the rubber plug.
Releasing the Shackle and Attaching the Lockbox
-
Open the Shackle
Slide and hold the shackle release to the left while pulling up on the shackle.
-
Secure the Lockbox
Place the lockbox over a door knob or handle to attach it securely.
Locking Your Lockbox
-
Insert Keys
Place the desired keys into the key storage area of the lockbox.
-
Close the Compartment
Shut the key storage area securely.
-
Secure the Dials
Rotate the dials to a random combination to lock the box and secure the keys inside.
Note: Test your new combination to ensure it works properly, and always return the reset lever to its original (locked) position to secure the lockbox.